E-MAG 3 Step Installation 

Estimated time - 2 to 4 hours

1   Install Drive Gear: 

• Recover the non-impulse drive gear from your old mag and install it on your E-MAG. If you don't have a suitable drive gear, E-MAG can provide one.  

2 Connect Control Leads & Harness:  

• Switch - Connect your existing ignition switch ("P Lead"). 

• Power  - From your 12 volt power buss. 

• Ground  - Connect  directly to engine case ground.

• Tach - (optional)  

• MAP  - Connect MAP sensor tube to fitting on ignition.

• Spark Plugs and Harness Kit 

3  Install & Set Timing with Quick-Set TM: 

• Pre-install the ignition(s) at any orientation that's convenient. You won't move them again so secure for operation.  Position the engine at TDC. 

• Power the ignition ON.  Disconnect the MAP tubing where it ties into the craft and blow into it (minimum 1/2 psi for 1 second).  The built-in LED will flash RED.  Blow into the tube a second time and the LED will flash GREEN, indicating that timing has been set.  Power cycle the ignition and your done. 

Note: You can set timing on two E-MAGs in exactly the same way in exactly the same amount of time - 30 to 60 seconds.

[ Home ] [ Introducing E-MAG ]

E-MAG Ignitions (TM)

2014 Greg Street. Azle, Texas 76020 

Copyright 2006.  All products, features, and prices are subject to change without notice.